Pocket Hole Screw 1-1/2″ Coarse 500

Description

About:

• Kreg part # SML-C150-500
• 1-1/2″
• #8 Coarse
• Washer-Head
• 500 count
• Longer length for joining 7/8 to 1-1/8 thick softwoods

Why Kreg Pocket Hole Screws are better:

• Extra metal in head eliminates head snapping off
• Deep square drive prevents driver from jumping out
• Large Maxi-Loc Head STOPS when it hits bottom of the hole
• Case hardened STEEL screw
• Zinc coating
• Sharp edge of Self-Tapping tip drills a cleaner pilot hole
• Needle sharp point minimizes walking

About the Maxi-Loc™ Head:

Kreg’s most common screw head type is the Maxi-Loc™ (SML) which is a washer head screw. The large bearing surface of the washer head is designed to seat securely in the bottom of the pocket, providing a tremendous amount of consistent clamping force on the joint line. Our second head style is referred to as a pan head (SPS). The pan head is a slightly smaller head size that allows it to easily get below flush when joining 1/2 material. This is particularly helpful when joining 1/2 to 1/2 plywood for drawer boxes.

Coarse thread is good for softer woods:

• Pine, Cedar, Fir, Spruce, Basswood, Butternut, Poplar, Aspen, Plywood, Melamine, MDF, and Particle Board